Waterloo F2002 Manual do Utilizador descarregar pdf (Página 3)

DIVIDER INSTALLATION

Items Needed:

10-24 x 5/16 Hex Screw (Qty: 24)

Dividers (Qty: 6)

5/16" Wrench

Process:

• Decide which position and in which drawers they would

best serve your needs.

• The dividers are cut to t right to left in the drawers. If you

prefer to run them front to back, they may be trimmed in

length to do so.

• Position the dividers in the desired locations.

• Thread screws through the bottom of the drawer and into

each divider. Tighten all the screws.

DRAWER LINER INSTALLATION

Items Needed:

Drawer Liner Roll

Scissors

Process:

• Remove the non-slip drawewr liner from the roll. The

drawer liner may be cut with scissors to t each drawer

and around the drawer divideres, if necessary.

CHEST ATTACHMENT (if purchased)

Items Needed:

10-24 x 5/16 Hex Screw (Qty: 4)

1/2" Wrench

Process:

• Remove the wooden top from the cart.

• Remove the top two drawers of the cart (refer to the

drawer removal instructions).

• Lift the chest onto the cart. Line up the holes in the bot-

tom of the chest with the holes in the top of the cart.

• Attach the chest using (4) screws inserted from the

underside of the top of the cart. (See Figure 8)

• Wrench tighten all screws.

• Replace the drawer (refer to drawer installation instruc-

tions).

• To remove, reverse procedure.

OPERATION

Handle Lever

LOCKING AND UNLOCKING THE UNIT

Locking the Unit:

• Always check the unit to make sure all the drawers are

completely closed before locking.

• Pull handle lever out.

• Insert the key into the lock and turn it clockwise.

• Release lever.

Figure 5

Unlocking the Unit:

• Pull the handle lever.

• Insert key into the lock and turn it counterclockwise.

• Release lever.

Figure 3

Figure 4

Screw

Drawer

Dividers

1 2 3 4 5 6 7 8 ... 23 24

Comentários a estes Manuais

Sem comentários

Waterloo F2002 Manual do Utilizador Página 3

Comentários a estes Manuais

Manuais e produtos relacionados com Ferramentas Waterloo F2002